Stable printing process on your production line

Far more than twenty parameters are already acting on the quality and the performance of your production line during stencil printing. In the manufacture of electronic assemblies, the printing process can cause up to 65% of the errors. An adapted layout in combination with an optimal release behaviour is decisive for the production run, because only a stable production line is efficient.

In 2008 the Christian Koenen GmbH opened its own laboratory for research an development - the Application Center. The technical facility enables you to outsource the research and development work to improve your printing process. This creates valuable production time for you, as the performance of your production line is not affected.

At the Christian Koenen GmbH you get sound process consulting from experts: The adaptation of your processes is carried out by us with your parameters and your materials. Over the long-term the constant further development of our products secures you an advantage over the competition.

Measurement of a circuit board topography

In the graphic one clearly sees a superelevation of the Vias, the solder resist and the positioning print.

Unevenness measurement of a Flex-Substrate

Unevenness of a connector installation position (grid 0.4 mm).

Your contact partner

Sebastian Bechmann
Head of Application

+49 89 66 56 18 - 172

Tim Böck

+49 89 66 56 18 - 173



Christian Koenen GmbH
HighTech Stencils

Otto-Hahn-Straße 24
85521 Ottobrunn-Riemerling


+49 89 66 56 18 - 0
F +49 89 66 56 18 - 330

Up to date

Don't miss any more news, subscribe here to our Newsletter.



© 2022 Christian Koenen GmbH