Contact
Shop

Lab for Research & Development

Much more than twenty parameters affect quality and performance of your production line as early as at the stencil printing stage. In the manufacture of electronic assemblies, the printing process may cause up to 65 % of the defects. An adapted layout in combination with optimal release behaviour is crucial for the course of production, since only a stably running production line is economic.

In 2008, Christian Koenen GmbH opened the in-house lab for research and development – the Application Center. The technical equipment allows you to outsource the research and development work for the improvement of your printing process. This will buy you valuable production time, as the performance of your production line will not be affected.

We will adapt your processes using your parameters and your materials. The permanently ongoing development of our products ensures your long-time advantage over the competitors.

Measuring of a Circuit Board Topography

Measuring of a circuit board topography

The figure clearly shows excess height of the vias, the solder resist and the positioning pressure.

Measuring of the Unevenness on a Flex Substrate

Measuring of the unevenness on a Flex substrate

The figure shows unevenness of a connector slot on a Flex substrate (grid 0.4 mm).

Your Contact Partners


Sebastian Bechmann
Head of Application

Available for you on the phone:
+49 89 66 56 18 - 172

sb@ck.de

Daniel Rudolph


Daniel Rudolph
Application

Available for you on the phone:
+49 89 66 56 18 - 173

dr@ck.de